Table of Contents
Advertisement
SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
I
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll core holder.
If part A is not hidden even after turning the
handle until it can no longer be turned, the
roll core holder may not be fully inserted.
Return to step 6.
See the following for further instructions.
For information on taking-up with printed side in, see
the following section.
Taking-up with printed side outU
Printed Side Facing Out" on page 51
Basic Operations
Take-up with the Printed Side Facing
In
A
"Take-up with the
B
49
Pass the media through the front side of the
media guide bar, and then attach the media to the
take up roll core with tape.
In the order shown in the illustration, tape the
media to the take up roll core. When attaching in
the center, attach using tape while pulling the
center of the media straight. When attaching on
the left and right, attach using tape while pulling
the media sideways.
c
Important:
If the media is lifted up between the attached
pieces of tape, the media will not be taken up
correctly. If the media is lifted up, we
recommend either adding tape and attaching
it uniformly or fixing creases at the leading
edge of the media.
Press the d button in the control panel to feed
enough media for a single wrap around the roll
core.
Advertisement
Table of Contents
