Media Loading (Sc-F7000 Series); Loosen The Right Roll Core Holder Locking Screw; And Remove The Roll Core Holder From The Roll; Lower The Roll Onto The Roll Support - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
E
Loosen the left roll core holder locking screw and
remove the roll core holder.
F

Lower the roll onto the roll support.

G
To prevent the media from sliding off the roll,
support the roll at its right end.
H

Loosen the right roll core holder locking screw

and remove the roll core holder from the roll.

Basic Operations
I
Lower the roll onto the roll support.

Media Loading (SC-F7000 Series)

The auto take-up reel unit automatically takes up media
as it is printed. This improves the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side out
Taking-up with printed side out places the printed
surface on the outside of the roll.
Taking-up with printed side in places the printed
surface on the inside of the roll.
!
Caution:
❏ Be sure that your hands or hair do not get
caught in the Auto Take-up Reel Unit while it
is in operation.
Failure to observe this precaution could result
in injury.
❏ Perform the following procedure to correctly
secure the roll core for the Auto Take-up Reel
Unit into place.
Injury may occur if the take-up roll falls.
54
Printed side in