Epson SC-F7100 Series User Manual page 45

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Buttons that are used in the following settings
A
After checking that the printer is ready, press the
button, and press the Z button.
B
Check that the trailing edge of the printed media
is fed to the position over the cutter groove, and
open the front cover.
If you have printed the amount of media
remaining, press the u button to rewind the
media so that this information will remain on the
roll after the media is cut.
Basic Operations
When the Auto Take-up Reel Unit is used on the
SC-F7000 Series, raise the tensioner.
C
Open the front cover, and move the media
holding plates out of the way.
Sliding media holding plates
Move the media holding plates to the right and
left sides of the platen. Hold both tabs on the
media holding plates to move them.
Insertable media holding plates
Remove the media holding plates from both
edges of the media.
45