Epson SC-F7100 Series User Manual page 86

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
!
Caution:
❏ Store ink packs in a location out of reach of
children.
❏ During maintenance, wear protective
clothing, including protective eyewear, gloves,
and a mask.
Should ink contact your skin or enter your eyes
or mouth, take the following actions:
❏
If fluid adheres to your skin, wash it off using large
volumes of soapy water. Consult a physician if the
skin appears irritated or is discolored.
❏
If fluid enters your eyes, rinse immediately with
water. Failure to observe this precaution could
result in bloodshot eyes or mild inflammation. If
problems persist, consult with a physician.
❏
If fluid enters your mouth, consult with a
physician as soon as possible.
❏
If swallowed, do not induce vomiting. Consult
with a physician as soon as possible. If vomiting is
induced, vomited material may enter the
windpipe, which is dangerous.
❏ Note the following points when refilling ink.
❏
Gently tear off the ink pack spout opening.
If you cut the nozzle too quickly, ink may splatter.
❏
Do not squeeze open ink packs. Ink may spill.
❏
Gently tilt the ink pack when pouring ink into the
ink tank.
Maintenance
c
Important:
❏ Epson recommends the use of genuine Epson
ink packs.
Epson cannot guarantee the quality or
reliability of nongenuine ink. The use of
non-genuine ink may cause damage that is not
covered by Epson's warranties, and under
certain circumstances, may cause erratic
printer behavior.
Information about non-genuine chip unit
status may not be displayed, and use of
non-genuine ink is recorded for possible use in
service support.
❏ Genuine Epson ink, other than those specified
here, could cause damage that is not covered
by Epson's warranties.
"Options and Consumable Products" on
U
page 130
❏ Do not place items on the ink tank or subject
the ink tank to strong impacts. The ink tank
could be detached.
Contact your dealer or Epson Support.
A
If the Check Ink Levels message is displayed on
the control panel screen, check the ink level in the
ink tank via the scale on the ink pack.
If the remaining ink level is greater than 70 mm
from the base of the ink tank:
We recommend continuing to use the printer
until the remaining ink level is 70 mm from the
base of the ink tank so that you can use all the ink
in a new ink pack to refill the ink tank.
86