Epson SC-F7100 Series User Manual page 33

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
G
Raise the lift lever on the right side of the printer
to lift the media into position, then firmly insert
the roll holder.
If the roll of media has an outer diameter which is
less than 140 mm, lift it up by your hands, and set
it to the roll holder as described in Step 5.
H
To ensure the roll holder is inserted into the roll
core sufficiently, push the center section on the
side of the roll holder towards the roll end twice.
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly
during printing because of slippage between
the roll holder and roll core.
This may cause banding in the print results.
Basic Operations
I
Tighten the roll holder fixing screw until the
screw no longer turns to fix the roll holder in
place.
c
J
Rotate the handle until part A in the illustration
below is fully inserted.
33
Important:
If the roll holder fixing screw is loose, the roll
holder may move during printing. This could
cause stripes and unevenness in the print
results.