Table of Contents
Advertisement
SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll holder.
If part A is still visible even after the handle
has been turned fully, rewind the handle.
Loosen the roll holder fixing screw on the right
side, and then restart from Step 8.
K
Confirm that the right and left edges of the
attached roll are aligned.
If the right and left edges of the roll are not
aligned, realign them.
L
Raise the media loading lever.
M
Pull out the media and insert it into the printer.
Basic Operations
Note:
Media that is heavy and difficult to unroll can be
fed by pressing the drive switch on the left roll
holder.
Printable Side Out
Printable Side In
N
Insert the media past the pressure rollers and
lower the media loading lever to hold it in place.
Confirm that the left edge of the media passes
over the center of the square in the label on the
loading guide.
c
40
Important:
Perform Steps 14 to 4 in reverse order and
repeat the loading process if the left edge of the
media is not within the guides. Do not
attempt to reposition the roll holders while
they are inserted in the media.
Advertisement
Table of Contents
