Table of Contents
Advertisement
INSTALLATION
WIRED MODEL INSTALLATION
SPEED SENSOR & MAGNET
NOTE: Wired cadence is optional. Please refer to WIRED
SPEED AND CADENCE/WL2X DOUBLE WIRELESS SPEED AND
CADENCE MANUAL for installation.
Step 1:
Use the zip-tie supplied to hold loosely the wired speed
sensor and mounting pad to the inside of either fork leg.
We recommend mounting it as high up on the fork leg
as possible to protect it from being hit by rocks,
branches or other objects while riding. (Fig. 1)
Step 2:
Tighten the spoke magnet to any spoke on the "sensor
side" of the front wheel so that it passes over the
alignment mark on the sensor. (Fig. 1, 2)
Step 3:
Attach the alignment setup spacer to the magnet
temporarily. (Fig. 3)
Step 4:
Slide and rotate the sensor until the alignment mark just
touches the spacer tip on the magnet. (Fig. 4)
Step 5:
Route the sensor wire up the fork blade and secure it
with the tape. Wrap excess wire around the front brake
cable housing, leaving enough slack to attach the
mounting bracket easily to the handlebar and allow for
movement of the bar and stem. CAUTION: When
installing the speed sensor on a suspension fork,
make sure that the fork is fully extended to ensure
there is enough wire to reach the mounting bracket
properly. Excess sensor wire should be taped down
or wrapped around the brake cable housing for
safety.
Step 6:
Snug the zip tie down to hold the sensor in its final
position.
Step 7:
Remove the spacer and verify that the magnet and
sensor spacing stayed the same. (Fig. 5)
Note: Do not use a zip-tie tightening tool or a third hand tool
when doing the final tensioning of the zip-ties. This can tear and
damage the sensor or transmitter.
Hide quick links:
Advertisement
Table of Contents
