Vetta V100A Manual page 27

SETUP: ALTIMETER MEMORY 1 & 2
After Altimeter "ON" is selected, the computer
advances to Altimeter Memory 1 Setup. This is
the first of two Altimeter Memory settings in
which the user can enter known elevation
values to serve as quick, pre-ride Altimeter
calibrations. When a rider frequently starts his
or her ride from home or another location with
a known elevation, the Altimeter Memory
feature enables them to recalibrate the
computer quickly and easily at the start of a
ride. Note: The Altimeter must be
recalibrated every time the rider begins a
new ride by accessing the Pre-Ride Altimeter
Calibration Setup through the Normal
Operating Mode (NOM) (Press and hold
Buttons #1 and #2 for 2 seconds in the
ALT/% screen mode).
In the Initial Altimeter Memory 1 Setup screen,
the display shows 5 zeros (00000) on the
upper line with the right digit flashing. Press
Button #2 to toggle to the desired number for
the elevation you intend to set and press
Button #1 to select it and advance to the
next digit. Continue to use Button #2 to
advance the digits from "0" to "9" as needed
to set a specific elevation. Note: To set a
negative, below sea level elevation, the rider
must enter a minus sign (-) at the front of the
elevation reading and select it by pressing
Button #1. Note: The default elevation value
for both Memory 1 and Memory 2 is "00000"
or sea level. The largest possible positive
elevation value is "99999" feet or meters.
The largest possible negative elevation value
is "-9999" feet or meters.