Listing Of Functions; Battery Installation - Vetta C-06 CYCLE COMPUTER Owner's Manual

LISTING OF FUNCTIONS

BATTERY INSTALLATION

A76 1.5v Battery
SPEEDOMETER ( m/h or km/h )
Tells you your instantaneous speed. Accurate to 0.5 mph or kmph.
TRIP ODOMETER ( FLASHING)
Tells you the distance for your current ride from 0 to 999.9 mi. or km. Reset the
TRIP ODOMETER by holding the key down for 2 seconds while in the TRIP
ODOMETER MODE (
CUMULATIVE ODOMETER (
Tells you your cumulative distance for the year from 0 to 9999 mi. or km.
DIGITAL 12/24 HOUR CLOCK ( )
Gives you the time of day in a 12 or 24 hour format.
The C-06 uses a common A76 1.5v button cell battery. Replacement batteries are
available at most camera shops and from your Vetta retailer. Under normal usage
a battery should last approximately one year. NOTE: Most problems that occur
with cycle computers are caused by dead or weak batteries. If you are having
problems with your computer's operation, check and replace the battery first.
STEP 1
Remove the battery cover from the bottom of the computer using a small flat
blade screwdriver.
STEP 2
Install the battery into the battery compartment with the positive (+) side of the
battery facing the compartment door. Be careful when you are installing the
battery not to bend any of the battery contacts.
STEP 3
Press the battery cap firmly into place making sure that the rubber o-ring seal
does not get pinched or distorted as this will compromise the waterproofing of the
FLASHING).
SOLID)