Installation Wired Model Installation; Speed Sensor & Magnet - Vetta V100HR Manual

To change any value or correct any unit errors made during
Initial Setup, you must re-enter one of the two NOM Setup
programs in the V100HR. The first NOM Setup program covers
heart rate specific functions and the second covers cycling
specific functions and features.
1. To correct or change heart rate values in Setup: Re-enter HR
Setup in NOM by pressing Buttons #1 and #2 simultaneously
for 2 seconds in the HR/% screen mode.
2. To correct or change cycling values in Setup: Re-enter Setup
in NOM by pressing Buttons #1 and #2 simultaneously for 2
seconds in the SPD/DST screen mode.
Note: You may exit from either NOM Setup program at any
time by pressing Button #3.
INSTALLATION
WIRED MODEL INSTALLATION
SPEED SENSOR & MAGNET
NOTE: Wired cadence is optional. Please refer to WIRED
SPEED AND CADENCE/WL2X DOUBLE WIRELESS SPEED AND
CADENCE MANUAL for installation.
Step 1:
Use the zip-tie supplied to hold loosely the wired speed
sensor and mounting pad to the inside of either fork leg.
We recommend mounting it as high up on the fork leg as
possible to protect it from being hit by rocks, branches or
other objects while riding. (Fig. 1)
Step 2:
Tighten the spoke magnet to any spoke on the "sensor
side" of the front wheel so that it passes over the
alignment mark on the sensor. (Fig. 1, 2)
Step 3: Attach the alignment setup spacer to the magnet
temporarily. (Fig. 3 )