Ride Data Reset; All Clear Total Reset - Vetta V100A Manual

RIDE DATA RESET

To reset current ride, Freeze Frame and Altitude data to zero (DST,
RT, TT, AVG & MAX SPD, AVG & MAX CAD*, TOT & MAX ALT, MAX %
& MAX % (-), MAX & MIN TMP, STP, ID and IA), make sure the
timers (RT/TT) are turned OFF and press Button #3 for 2 seconds
in any primary screen mode except STP/ID or STP/IA.
WARNING: The Altimeter must be re-calibrated after any
ride data reset and before the next ride. See the section on
Altimeter Calibration Setup below. *(optional)

ALL CLEAR TOTAL RESET

All settings entered in Initial Setup, as well as all accumulated
ride data, can be cleared by performing an All Clear Total Reset.
To clear the computer, press all three buttons simultaneously and
hold for 5 seconds in any screen mode. When the computer is
cleared, the master screen will appear and show all LCD
segments for 3 seconds. The computer will then automatically
enter Initial Setup mode to be reprogrammed.
Note: Both Initial and Normal Operating Mode Setup utilize the
same sequence of Setup screens. Initial Setup is activated after a
battery installation or change, or after an "All Clear Total Reset"
has been performed. All units and values must be (re)entered
during Initial Setup. The Normal Operation Mode Setup program
allows the user to change or correct any value or units easily. To
access NOM Setup, press and hold Buttons #1 and #2 for 2
seconds in the SPD/DST screen mode. Scroll to the value you
wish to change quickly by pressing Button #1 successively.