Wired Speed Sensor & Magnet - Vetta Solar Flare500-111 Instruction Manual

Adjust its position so it can be read while riding and
then tighten the Screw Strap.
Wired Speed Sensor & Magnet
Bladed Spoke
Zip-Tie
Magnet
Spoke
Wired Speed
Fork Leg
Sensor
Spacer
Spoke Spacer Tip
Bladed
Spoke Magnet
Bladed
Spoke Magnet
Wired Speed
Sensor
Magnet
Sweep Path
Bladed
Spoke Magnet
Alignment
Mark
11
1. Attach the wired speed sensor with the zip-ties
supplied.
2. Tighten the bladed spoke magnet to the bicycle.
3. Adjust the sensor & magnet spacing with the spacer.
4. Remove the spacer after tightening the zip-ties
down to hold the sensor in its final position.
Note: Mount the sensor as high up on the fork leg as
possible.
Important: Use the tape provided in the package
rather than the Zip-Ties to hold wires to the frame,
fork, and bars or stem to avoid damaging or cutting
the wires accidentally. Make sure excess wire is
taped down or wrapped around brake cable housing
to secure it.
Note: Be sure to leave enough slack in the wire to
accommodate the movement of the fork.
12