Vetta V100A Manual page 34

SETUP: SYSTEM CHECK
After the Programmable Odometer is set, both the Initial and
Normal Operating Mode Setup programs will automatically
advance to the System Check screen sequence. System Check
displays all value and unit settings chosen during Setup in a 6
screen sequence with the Altimeter "ON", or a 5 screen sequence
with the Altimeter "OFF". Each screen in System Check appears
for 5 seconds and will blink. When the review is complete, the
computer automatically exits Initial Setup System Check and
advances to the
SETUP: ODOMETER
Bike I and Bike II have separate, programmable
odometers. On a new computer the Odometer
screen should read "00000" for both. To confirm
this initial zero setting, simply press Button #1
successively to select each flashing digit and
advance to System Check. To reenter mileage
achieved after a battery change, follow
these steps:
Step 1: When the far right digit begins to
flash, press Button #2 to scroll to the
desired number.
Press Button #1 to select this number
Step 2:
and advance to the next flashing digit.
Step 3: Repeat this procedure for each digit
until the correct mileage figure is
displayed (99999 = maximum). When
Button #1 is pressed to select the final
digit in the sequence, the Odometer
setting is completed and the computer
automatically advances to the System
Check screen.
SPD/DST screen in Normal Operating Mode.