Battery Installation; Head Unit - Vetta V100A Manual

BATTERY INSTALLATION

HEAD UNIT

The V100A head unit uses a CR2032 3V lithium button cell
battery. IMPORTANT: Most cycle computer problems
are caused by weak or dead batteries. See the
Troubleshooting section near the end of this manual for
details.
Step 1: Remove the battery cover from the bottom of the
computer using a coin. Remove the old battery.
Install a new battery as shown with the positive (+) side
Step 2:
facing out. Do not touch or bend any of the battery
contacts during installation.
Step 3: Screw the battery cap firmly into place making sure the
o-ring seal does not get pinched or distorted.
CAUTION: To avoid damage to the battery cap, do not over
tighten.