Vetta V100A Manual page 31

SERVICE TIMER NOTES
• Accumulated Ride Time (upper line) operates in conjunction
with the other timers and starts as soon as the wheel turns. It
stops automatically when the computer receives no input from
the wheel for 3 seconds.
•
The Service Timer screen can be viewed in both the NOM
Setup mode and in the System Check screen sequence. Access
NOM Setup through the SPD/DST screen mode by pressing
Buttons #1 and #2 simultaneously for 2 seconds with RT/TT
timers off.
SETUP: SERVICE TIMER
The Service Timers, one for each bike, may be
programmed with a select number of ride time
hours as the interval for servicing the bicycle or
any component on it, such as a front or rear
shock. Accumulated Ride Time is displayed on
the upper line and the Service Time interval is
set and displayed on the lower line. In the
Service Timer Interval Setup mode, the hour
digits appear on the lower level with the right
hand digit flashing. Note: The default setting
for the Service Timer is "0000" hours, which
means the Service Timer is turned off.
To set a service interval (in hours only)
Step 1:
scroll to the first digit of the number
you want to set using Button #2 and
select it by pressing Button #1. Note:
The Service Timer sets and displays
whole hours only. It does not display
minutes.
Proceed until all the digits for the
Step 2:
service interval have been selected,
then press Button #1 again. (1999
hours = maximum)