Vetta V100A Manual page 32

•
To stop the Service Timer icon from flashing: A) Reset the
accumulated Ride Time hours (upper line) to zero "0" through
the NOM Setup sequence. The Service Timer interval may also
be reprogrammed at this point. B) Change TT setting to a
number larger than accumulated RT. C) Set TT to zero "0000"
(disable the Service Timer).
•
The Service Timer option can be disabled in Initial or NOM
Setup mode by entering and selecting a value of zero "0000"
hours as the service time interval (lower line).
•
After user sets or resets the service time interval in NOM Setup,
accumulated Ride Time digits (upper level) will start blinking
(as shown in illustration below). Press Button #2 for 2 seconds to
reset RT digits to zero. Press Button #3 to exit to the NOM
System Check. Press Button #3 again to return to the SPD/DST
primary screen.
SETUP: SPEED UNITS
The "M/hr" symbol will appear on the screen
with the letter "M" flashing. To select miles per
hour as the unit of speed, press Button #1. To
scroll to kilometers per hour, press Button #2
and "KM/hr" will appear with the letters "KM"
flashing. Press Button #1 to select and advance.
Note: If "M/hr" is selected as the unit of speed,
then miles (m) is automatically set as the
unit of distance. If "KM/hr" is selected, then
kilometers (Km) is automatically set as the
unit of distance.