Power Optional Redlink™ Accessories - Honeywell TH8320R1003 Vision Pro 8000 Product Data

®
VISIONPRO 8000 WITH REDLINK™
POWER OPTIONAL REDLINK™
ACCESSORIES
Outdoor air sensor
1. Install 2 fresh AA lithium batteries.
Portable Comfort Control
1. Install 3 fresh AA alkaline batteries.
Indoor air sensor
1. Install 2 fresh AAA alkaline batteries.
RedLINK™ Internet Gateway
1. Connect power cord to an electrical outlet not controlled
by a wall switch.
2. Connect ethernet cable to router and the RedLINK Inter-
net Gateway.
68-0312—01
MCR32937
Fig. 22.
MCR32939
Fig. 23.
MCR32938
Fig. 24.
TrueSTEAM
1. Wire and power TrueSTEAM.
2. Connect the ABCD terminals between TrueSTEAM and
the THM4000 Wireless Adapter.
3. Adjust the DIP Switches on TrueSTEAM as follows when
using the Wireless Adapter:
• DIP3: UP
• DIP4: UP
• DIP5: DOWN
THM4000R1000
Fig. 26. Powering TrueSTEAM wireless adapter.
Entry/Exit Remote or Vent Boost Remote
1. Remove the cover.
2. Insert the CR2450 coin cell battery (included) into the
slot at the bottom of the remote. See polarity marking on
the remote.
Fig. 27. Installing Entry/Exit Remote or Vent Boost Remote
3. The LED will briefly flash green. If it flashes red, battery
is not good.
12
Fig. 25.
TrueSTEAM
1 2 3 4 5
ON
OFF
MCR31476
MCR33269
battery.
M32940
6