Selecting Thermostat Location; Installing Wallplate - Honeywell TH8320R1003 Vision Pro 8000 Product Data

®
VISIONPRO 8000 WITH REDLINK™

Selecting Thermostat Location

Install the thermostat about 5 ft. (1.5m) above the floor in an area
with good air circulation at average temperature. See Fig. 13.
NO
NO 5 FEET
[1.5 METERS]
Fig. 13. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall behind
the thermostat.

Installing Wallplate

CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before wiring.
NOTE: For best RedLINK performance, mount thermo-
stats at least 2 feet apart.
The thermostat can be mounted horizontally on the wall or on a
4 in. x 2 in. (101.6 mm x 50.8 mm) wiring box.
1. Press button on top and pull to remove the wallplate.
Fig. 14. Separate wallplate from thermostat.
68-0312—01
NO
YES
M19925
2. Position and level the wallplate (for appearance only).
3. Use a pencil to mark the mounting holes.
4. Remove the wallplate from the wall and, if drywall, drill
two 3/16-in. holes in the wall, as marked. For firmer
material such as plaster, drill two 7/32-in. holes. Gently
tap anchors (provided) into the drilled holes until flush
with the wall.
5. Position the wallplate over the holes, pulling wires
through the wiring opening. See Fig. 15.
6. Insert the mounting screws into the holes and tighten.
Fig. 15. Mounting wallplate.
Installing VisionPRO® 8000 with
RedLINK™
Connect Power
1. Insert supplied AA alkaline batteries for primary or
backup power.
Fig. 16. Insert AA batteries.
NOTE: When the thermostat is NOT used with the Equip-
ment Interface Module or the TrueZONE Wireless
Adapter, a C wire is required for RedLINK.
10
C S1
S1
K
S1 S1
R
C W O/B
R
Y
Y
U1
G
G
U1
W2 AUX
E
U2
Y2 Y2
U2
L A