Linking Thermostat To Equipment Interface Module (If Used); Linking Redlink Accessories; Performing Initial Setup - Honeywell TH8320R1003 Vision Pro 8000 Product Data

PERFORMING INITIAL SETUP

NOTE: If the thermostat is wired directly to the equip-
ment, 24 VAC (C wire) is required to connect
RedLINK accessories. Turn on 24 VAC before per-
forming the initial setup.
Initial setup options define the type of system you are installing:
• Residential or commercial
• Non-zoned or zoned
• Used with or without an Equipment Interface Module
(THM5421)
• Used with or without the TrueZONE Wireless Adapter
(THM4000)
1. Follow prompts on the screen to select the appropriate
options.
APPLICATION
residential
Fig. 28. Select application (residential or commercial).
NOTE: If you are connecting the thermostat to the True-
ZONE Wireless Adapter (THM4000), refer to the
TrueZONE instructions to link the thermostat and
RedLINK accessories.
Linking Thermostat to Equipment
Interface Module (if used)
1. In thermostat setup, when you are prompted to answer
TSTAT CONTROLS AN EQUIP. MODULE: select yes,
then press Next.
2. Press and quickly release the CONNECT button on the
EIM. Make sure the "Connected" light is flashing green.
Fig. 29.
Fig. 30. EIM CONNECT button.
NOTE: If the "Connected" light does NOT flash green,
another system may be in the listening mode.
Please exit the listening mode at the other sys-
tem and then try again.
Green Flashing: In Listening Mode - system is
ready to add RedLINK devices.
Green Steady: RedLINK devices are communi-
cating.
Red: RedLINK device(s) are NOT communicat-
ing. Check EIM and RedLINK devices.
3. While the "Connected" light is flashing green on the EIM,
press Next on the thermostat. After a short delay, the
screen will show the thermostat is connected.
4. Press Next, as directed on screen, to link RedLINK
accessories.

Linking RedLINK Accessories

1. When you see the prompt Connect RedLINK Accesso-
ries?, touch No or Yes.
a. If you select No, continue to step 5.
b. If you select Yes, you will be prompted to Press Con-
nect on New Accessories. Continue to step 2.
Connect RedLINK
Accessories?
Fig. 33. Connect RedLINK accessories.
NOTE: Accessories must be at least 2 feet away from the
thermostat or EIM during the linking process.
13
®
VISIONPRO 8000 WITH REDLINK™
CO NN EC
TE D
C O N N E C
T
Fig. 31.
Fig. 32.
MCR33970
68-0312—01