Set Up Dehumidification With Dehumidifier - Honeywell TH8320R1003 Vision Pro 8000 Product Data

®
VISIONPRO 8000 WITH REDLINK™
6. Set the Dehumidification Control. See Fig. 214. For more
information about these options, see "Dehumidification
using the Cooling System" on page 86.
NOTE: ISU 1014 gives the option to lockout ventilation
on calls for dehumidification. This helps main-
tain the desired humidity level.
Dehumidification using a Dehumidifier
The Dehumidifier option requires a dedicated unit for
dehumidification. The thermostat can be set to control
dehumidification in all modes (Heat, Off, Cool [ISU 912]).

Set up Dehumidification With Dehumidifier

Some screens shown in this section may not appear on the
thermostat, depending on how you set up dehumidification.
1. Select the Dehumidification Equipment in ISU 900. See
Fig. 215.
68-0312—01
Fig. 213.
Fig. 214.
Fig. 215.
2. If optional remote wireless indoor sensors are installed,
you can choose which sensor you want to use for dehu-
midification control. For example, you can use one sen-
sor for humidification control, and another for
dehumidification. See "Wireless Indoor Sensor" begin-
ning on page 112 for more information.
3. If you are sensing humidity from two separate locations
(one for humidification and another for dehumidification),
you can select which humidity reading to display on the
home screen. See "Wireless Indoor Sensor" beginning
on page 112 for more information.
4. Select the terminals wired to the Dehumidifier. See Fig.
218.
88
Fig. 216.
Fig. 217.
Fig. 218.