Selecting Thermostat Location; Installing Wallplate - Honeywell VisionPRO 8000 Product Data

®
VISIONPRO 8000 WITH WI-FI

Selecting Thermostat Location

Install the thermostat about 5 ft. (1.5m) above the floor in an area
with good air circulation at average temperature. See Fig. 9.
NO
NO 5 FEET
[1.5 METERS]
Fig. 9. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall behind
the thermostat.

Installing Wallplate

CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before wiring.
The thermostat can be mounted horizontally on the wall or on a
4 in. x 2 in. (101.6 mm x 50.8 mm) wiring box.
1. Press button on top and pull to remove the wallplate.
Fig. 10. Separate wallplate from thermostat.
33-00096—01
®
NO
YES
M19925
2. Position and level the wallplate (for appearance only).
3. Use a pencil to mark the mounting holes.
4. Remove the wallplate from the wall and, if drywall, drill
two 3/16-in. holes in the wall, as marked. For firmer
material such as plaster, drill two 7/32-in. holes. Gently
tap anchors (provided) into the drilled holes until flush
with the wall.
5. Position the wallplate over the holes, pulling wires
through the wiring opening. See Fig. 11.
6. Insert the mounting screws into the holes and tighten.
Fig. 11. Mounting wallplate.
7. Connect common side of transformer to C terminal.
C
K
RC
R
U1
U1
U2
U2
Fig. 12. Connecting C wire to terminal block.
Wiring the Thermostat
1. Refer to Fig. 13. See Table 9 on page 84 for terminal
designations and "Wiring" beginning on page 84 for more
information.
2. Turn on 24 VAC NOW.
8
C S1
S1
K
S1 S1
R
C W O/B
R
Y
Y
U1
G
G
U1
W2 AUX
-E
U2
Y2 Y2
U2
L/A
A
CONVENTIONAL
S1 S1
S1 S1
W O/B
Y Y
G G
W2 AUX
-E
Y2
Y2
A
L/A
HEAT PUMP