BP-28
2.
Fit and clamp the new front pillar inner panel in place
for welding.
3.
Measure each measurement point (Refer to the BODY
DIMENSIONS) and correct the installation position.
4.
MIG plug weld all holes and MIG lap weld seams.
5.
Clean and prepare all welds, and remove all residue.
6.
After removing, apply the welding primer.
BEDBP6315
7.
Transcribe the cutlines to the new front pillar outer panel,
adding 30mm overlap to each end and cut to length.
8.
Drill 8mm holes along front pillar outer panel flanges
for attachment to other panels.
BEDBP6315A
BODY PANEL REPAIR PROCEDURE
BEDBP6315B
BEDBP6315C
BEDBP6320