BODY PANEL REPAIR PROCEDURE
NOTE
This procedure is to be used only for repair of minor
damage to the front side member and when it is
impossible to straighten the damaged front side
member. The following procedure illustrates a repair
for the front left side member.
The procedure may also be applied to the front right
side member.
REMOVAL
1.
Before cutting the front side member, remove the front
crash member assembly.
2.
Measure and mark the vertical cutlines on front side
member from tooling hole edge as shown in the
illustration.
BEDBP6101
3.
Drill out all the spotwelds to separate front side member.
BEDBP6201
BP-19
BEDBP6202
BFDBP6203
BFDBP6203A