BP-6
CARBON ARC WELDING
In areas where spot welding is not suitable, do plug welding
using a carbon are welding machine.
1.
Clamp the parts to be welded together tightly. Do not
exceed 1 mm of space between parts. A tolerance
greater than 1 mm will reduce the strength of the
welded area.
2.
Weld in the middle of the flange joint.
a)
Drill a hole 5~6 mm on one side of the flange
only, and weld within the hole.
1mm
Maximum
tolerance
BVQBP6008
Good
BVQBP6006
BODY PANEL REPAIR PROCEDURE
b)
Do not weld on the edge of the flange joint.
No good
BVQBP6009