BODY PANEL REPAIR PROCEDURE
6.
After removing, apply the welding primer.
INSTALLATION
1.
Transcribe the cutlines to the new quarter outer panel,
adding 30 mm overlap each end.
2.
Drill 8 mm holes in overlap areas and along upper and
lower flanges of the new quarter outer panel for MIG
plug welding.
3.
Apply body filler to the welded seam. Sand and finish.
Apply the two-part epoxy primer to the interior of the
quarter outer panel.
4.
Fit and clamp the quarter outer panel in place.
5.
Measure each measurement point (Refer to the BODY
DIMENSIONS) and correct the installation position.
BFDBP6720B
6.
MIG plug weld all holes and MIG butt weld seams.
BFDBP6721
BP-53
BFDBP6717A
BFDBP6717B