Hyundai 2008 Elantra Neos Body Repair Manual page 108

BODY PANEL REPAIR PROCEDURE
3. MIG plug weld all holes and MIG lap weld seams.
4. Clean and prepare all welds, and remove all residue.
5. After removing, apply the welding primer.
6. Transcribe the cutlines to the new side outer panel,
adding 30mm overlap to each end and cut to length.
7. Drill 8mm holes in overlap areas and along center pillar
outer panel flanges.
BEDBP6513A
8. Fit and clamp the new center pillar outer panel in place
for welding.
9. Measure each measurement point (Refer to the BODY
DIMENSIONS) and correct the installation position.
BEDBP6513B
10. Check the fit of the front and rear doors.
11. Reinstall center pillar outer panel.
12. Apply body filler to the outer center pillar seam. Sand
and finish.
BEDBP6511B
BP-43
BEDBP6517
BFDBP6510A