Hyundai 2008 Elantra Neos Body Repair Manual page 125

BP-60
13. Fit and clamp the new rear combination lamp housing
panel assembly in place.
14. Measure each measurement point (Refer to the BODY
DIMENSIONS) and correct the installation position.
15. MIG plug weld all holes.
16. Clean and prepare all welds, remove all residue.
BFDBP6710
17. Apply the two-part epoxy primer to the interior of the
rear floor side member.
18. Apply an anti-corrosion to the interior of the rear floor
side member.
(Refer to the CORROSION PROTECTION)
19. Prepare exterior surfaces for priming, using wax and
grease remover.
20. Apply metal conditioner and water rinse.
21. Apply conversion coating and water rinse.
22. Apply the two-part epoxy primer.
BFDBP6701C
BFDBP6701B
BODY PANEL REPAIR PROCEDURE
BFDBP6701C
BFDBP6701D