Burner Glass Installation - Heat & Glo PRIMO60 Installation Manual

F. Burner Glass Installation
Installation
1. Locate packaged burner glass pieces shipped inside
the fi rebox.
2. Position the burner glass tight to the burner tube as
shown in Figure 6.19.
Note: The burner glass is designed to fi t tightly. The
screws located adjacent to the burner glass locations may
be loosened in order to allow for more clearance when
placing the burner glass into the appliance.
Note: The two small pieces should be located at the right
end of the burner tube.
3. Slide both rows of glass tight to the screw heads located
in front of the pilot assembly.
NOTICE: Gaps between pieces of glass or between glass
and burner tubes will negatively affect fl ame appearance.
PILOT ASSEMBLY
*
=LARGE BURNER GLASS PIECES - QUANTITY PER UNIT
PRIMO48/PRIMO48ST = 6
PRIMO60/PRIMO60ST = 8
PRIMO72/PRIMO72ST = 10
Figure 6.19. Burner Glass Installation
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
38
LARGE BURNER GLASS PIECES*
SMALL BURNER GLASS PIECES (2)
LOCATED OPPOSITE OF PILOT ASSEMBLY
BURNER