Heat & Glo PRIMO60 Installation Manual page 36

HEAT-OUT-PRIMO Incorporated with HEAT-ZONE-PRIMO
* = Optional HEAT-OUT-PRIMO location
For wiring information, see Figure 8.8:
HEAT-ZONE-PRIMO incorporated with
HEAT-OUT-PRIMO.
HEAT-ZONE-PRIMO Collar
PowerFlow TM Heat
Management Toggle
LED COLOR
SWITCHES
Wall Switch
*The HEAT-OUT-PRIMO may be installed in either position shown above.
*Note: Remove only one of the two middle seal plates if installing
the HEAT-OUT-PRIMO. The other plate must remain installed.
** Use included zip ties to attach the flex ducting to the damper.
Figure 6.17. HEAT-ZONE-PRIMO and HEAT-OUT-PRIMO Features
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
36
*
HEAT-ZONE-PRIMO
**ATTACH WITH
ZIP TIE AT
DAMPER
HEAT-OUT-PRIMO
COLLAR
WARNING! Risk of Overheating! Damper MUST
be installed with crimped side up. Damper will not
function properly.
WARNING! Risk of Fire! Verify damper is opera-
tional. Overheating will occur if damper does not
open and close.
Heat-Out-Primo
HEAT-ZONE-PRIMO
DAMPER
*
HEAT-ZONE-PRIMO Collar