Heat & Glo PRIMO60 Installation Manual page 59

Trim Strip Joint-Crack Prevention and Repair
Trim strip joints around the fi replace will be affected
by exposure to increased temperatures, along with
other environmental and structural factors. The specifi c
methods presented above will help prevent or minimize
development of cracks.
If a crack does emerge, it can be permanently repaired
by fi lling it with spackling paste or paintable latex caulk,
followed by repainting. Fine cracks can be repaired using
an additional coat of eggshell paint.
8 INCHES ALL SIDES
Figure 10.5 Feather Mud Evenly
4. Glass Panel Instructions
KIT COMPONENTS
(1) Left Glass Panel
(1) Right Glass Panel
(1) Back Glass Panel (Single-sided models only)
(3) Glass Retaining Brackets
(2) Glass Clips
Single-Sided Models:
Set back glass panel, in location A in Figure 10.6 into fi re-
box. Back panel will sit on the heads of the screws hold-
ing the media tray in place. Set back glass panel against
the back wall of the fi rebox with the smooth side of the
glass facing outward. Place retaining bracket over panel
so holes in the bracket are against the fi rebox back. Use
two self-drilling screws to secure to the fi rebox back. En-
sure glass panel is stationary. See Figure 10.7.
Position the glass clip as shown in Figure 10.8.
NOTICE: Fasteners are not used with glass clip.
Set left side glass panel, in location B in Figure 10.6,
into fi rebox with the smooth side facing outward. Place
retaining bracket over panel so holes in the bracket are
against the fi rebox side. Use two self-drilling screws to
secure to the fi rebox side. See Figure 10.7. Ensure glass
panel is stationary.
Repeat for right side panel.
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
See-Through Models:
Position the glass clip as shown in Figure 10.8.
NOTICE: Fasteners are not used with glass clip.
Set left side glass panel, labeled B in Figure 10.6, into
fi rebox with the smooth side facing outward. Place retain-
ing bracket over glass panel so holes in the bracket are
against the fi rebox side. Use two self-drilling screws to
secure the bracket to the fi rebox side. See Figure 10.7.
Repeat for right side panel.
B
*Back panel used in single-sided models only.
Figure 10.6. Placement of Panels
Figure 10.7. Retaining Bracket Installation
A* C
RETAINING BRACKET
DETAIL
59