Heat & Glo PRIMO60 Installation Manual page 67

Granite Panel Installation
KIT COMPONENTS
(1) Left Panel
(1) Right Panel
(1) Back Panel (Single-sided models only)
(2) Retaining Brackets
CAUTION! Risk of Injury!
granite panel installation and removal be performed by
two qualifi ed service technicians.
Inside Granite Back Panel Weights
PRIMO48
51 lbs
See-Through Models: Start at Step 3.
1. Single-Sided Models:
Set back panel, in location A in Figure 10.21, into fi re-
box. Back panel will be held in place by the side pan-
els and will sit on the heads of the screws holding the
media tray in place. Set back panel against the back
wall of the fi rebox with the polished side of the panel
facing outward. Hold back panel in place while install-
ing the left/right panels per step 2.
2. Single-Sided Models:
Set left side panel, in location B in Figure 10.21, into
fi rebox with the polished side facing outward. Place
retaining bracket over panel so holes in the bracket are
against the fi rebox side. Use two self-drilling screws
to secure the bracket to the fi rebox side. See Figure
10.22. Repeat for right side panel.
3. See-Through Models:
Set left side panel, in location B in Figure 10.21, into
fi rebox with the polished side facing outward. Place
retaining bracket over panel so holes in the bracket are
against the fi rebox side. Use two self-drilling screws
to secure the bracket to the fi rebox side. See Figure
10.22. Repeat for right side panel.
B
*Back panel used in single-sided models only.
Figure 10.21 Placement of Panels
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
It is recommended that
PRIMO60 PRIMO72
63.5 lbs 76 lbs
A* C
RETAINING BRACKET INSTALLED
Figure 10.22. Granite Retaining Bracket
Granite Surround Installation
Note: Install granite pieces in the order indicated in
Figure 10.23.
1. Install leveling shoulder bolts to the granite transition
brackets. See Figure 10.24. The bolts can be used to
level the side granite pieces.
2. Install granite transition bracket on left and right sides
of appliance opening as shown in Figure 10.24. Attach
brackets with the two shoulder bolts and tighten.
CAUTION! Risk of Injury! Granite is heavy. Installation
of top and bottom granite pieces requires at least two
people.
Granite Weights Top/Bottom Pieces (Each)
PRIMO48 PRIMO60
29.4 lbs
1= REMOVABLE SIDE GRANITE
2 & 3= NON-REMOVABLE
TOP & BOTTOM GRANITE
FLUSH AT
1
EDGE
2
Figure 10.23 Sequence of Granite Piece Placement
PRIMO72
35.4 lbs 41.5 lbs
WALL
(1/2 INCH SHEETROCK)
3
1
FLUSH AT
EDGE
67