Heat & Glo PRIMO60 Installation Manual page 61

6. Install barrier glass supports on bottom left and right
sides using an existing screw, a self-tapping screw,
and shoulder bolt. See Figure 10.12 and 10.13. Install
rubber bumpers as shown in Figure 10.12 to protect the
barrier glass.
BARRIER
GLASS SUPPORT
SELF-TAPPING SCREW LOCATION SELF-TAPPING SCREW LOCATION
BARRIER GLASS SUPPORT BARRIER GLASS SUPPORT
EXISTING SCREW LOCATION EXISTING SCREW LOCATION
ATTACH RUBBER BUMPERS ATTACH RUBBER BUMPERS
Figure 10.12 Install Barrier Glass Supports
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
RUBBER BUMPER RUBBER BUMPER
SHOULDER BOLT SLOT SHOULDER BOLT SLOT
APPLIANCE OUTER
WRAP
A. REMOVE EXISTING
SCREW
LOWER ACCESS
COVER PANEL
B. POSITION BARRIER GLASS SUPPORT
D. DRIVE SELF TAPPING SCREW
C. REINSTALL EXISTING
SCREW
INSTALLED SHOULDER BOLT
INSTALLED BARRIER GLASS SUPPORT
(Install between appliance outer wrap and
lower access cover panel)
Figure 10.13 Install Barrier Glass Supports
61