Front Door Glass Assembly Installation; Inner Glass Door Assembly Replacement - Heat & Glo PALOMA-BL Owner's Manual

M. Front Door Glass Assembly Installation
Remove the front door assembly by pulling bottom of front
away from appliance and lifting it off of the spring-loaded
latches on top of the appliance (see Figure 8.36).
Refer to Figure 8.37: Position the four flat 1/4 in. (6mm)
spacer washers on the front door so that the four mounting
screws pass through them. Position the glass over the front
door.
Install the four protective barrels into the glass and the four
nylon washers on top of the glass.
From inside the door front, pass the screws through to the
outside and thread on the caps until tight.
Figure 8.36
Cap and Barrel Fastener System
Screw
Figure 8.37
Page 42
Nylon washer on back
and front of glass
Finishing Cap
Protective barrel sleeve
through hole in the glass
Heat & Glo · Paloma · 7031-220G
N. Inner Glass Door Assembly Replacement
Turn the appliance OFF and let it cool down before replacing
the inner glass door assembly.
With the front door assembly removed from the appliance,
remove the inner glass door assembly by disengaging the
spring-loaded latches at the bottom of the appliance and
lifting off of the two spring-loaded latches at the top of the
appliance.
Replace with a new inner glass door assembly.
Figure 8.38 Complete Assembly
CAUTION
Handle glass assembly with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.
February 8, 2006