Heat & Glo PRIMO60 Installation Manual page 48

LED Lighting
WARNING! Risk of Shock! Label all wires prior to
disconnection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
The functions and colors for the LED lighting on the
PRIMO appliance are controlled by the included wall
switch.
Figure 8.6. LED Switch Operation
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
48
OUT
Green
Wire
Yellow
Wire
Orange
Wire
OUT

TOP
COLOR
SWITCH
OFF IN
DARK BLUE OUT
GREEN IN
RED IN
WHITE OUT
LIGHT
OUT
BLUE
YELLOW IN
PURPLE OUT
LED Switch Wiring
Wire the LED switch with the included low voltage wire.
Be sure to install the switch and wiring according to the
orientation shown in Figure 8.6.
LED Switch Operation
Three white toggle switches are used to operate the
interior lighting for the fi replace. There are seven color
options. See Figure 8.6. Flipping a combination of these
three buttons activates the desired color. The chart in
Figure 8.6 shows the combinations for each of the seven
colors.
LED Color Switches
IN
Black
Wire
IN

MIDDLE BOTTOM
SWITCH SWITCH
IN IN
IN IN
OUT IN
IN OUT
OUT OUT
OUT IN
OUT OUT
IN OUT