Heat & Glo PRIMO60 Installation Manual page 77

BARRIER GLASS TABS
NOTE: INSTALL BARRIER
GLASS PRINTED SIDE
OUT."THIS SIDE OUT"
MUST BE LEGIBLE ON
BARRIER GLASS.
Figure 11.2. Replace Barrier Glass - Clean Face Finish
Removing Barrier Glass - Black Granite Finish
1. Slide side granite pieces inward toward center of fi re-
place to disengage from the key slots. See section 10.C.
2. Remove (unscrew) D-shaped retaining tabs.
3. The glass rests against the barrier glass support
bracket. See Figure 11.4.
4. Use suction cups to remove barrier glass.
5. Rotate/tilt the bottom of the glass outward to remove.
See Figure 11.4.
6. Set the glass on a prepared work surface.
Figure 11.3 Glass Gasket Detail - Black Granite Finish
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
GLASS GASKET BULB GLASS GASKET BULB
D-SHAPED RETAINING TAB
GLASS SUPPORT
BRACKET
NOTE: INSTALL BARRIER
GLASS PRINTED SIDE
OUT."THIS SIDE OUT" MUST
BE LEGIBLE ON BARRIER
GLASS.
Figure 11.4 Barrier Glass - Black Granite Finish
Replacing Barrier Glass - Black Granite Finish
1. Use suction cups to pick up barrier glass.
2. Place the top edge of the barrier glass behind the top
granite trim.
Note: Ensure the glass gasket is installed. The glass
gasket bulb should be positioned on the outside sur-
face of the barrier glass surround as shown in Figure
11.4. It is labeled "THIS SIDE OUT."
CAUTION! Risk of Injury! Glass gasket shall be in-
stalled on barrier glass! Hot glass will cause burns.
3. The glass rests against the barrier glass support
bracket as shown in Figure 11.4.
4. Attach and tighten the D-
TOP TOP
BOTTOM BOTTOM
GLASS GASKET BULB
LOCATED BEHIND GRANITE
BARRIER GLASS
shaped retaining tab.
Figure 11.4.
See
77