Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo 6000CLX-IPI-T Owner's Manual

14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 14.J.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. AN • 2/16
E. Burner Top Installation
1. Bend the two tabs upward as shown in Figure 14.1.
2. To install the fiber burner, mate the locating holes with
the guide sleeves. Install fiber burner top so that it
makes full contact with the underlying burner assem-
bly.
3. Ensure that the ports in the steel burner are visible
through the holes in the fiber burner top.
FIBER BURNER TOP
BEND TABS UP
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 14.1
LOCATING HOLES
AIR SCOOP
PILOT COVER
BURNER SHIELD
57