Glass Refractory Installation - Heat & Glo LUX36 Owner's Manual

F. Glass Refractory Installation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation.
CAUTION! Glass is fragile. Handle with care.
1. Remove rear and side glass retainer brackets as shown
in Figure 14.10. Retain fasteners for use in Steps 3-5.
2. Locate notch on rear corners of log mount plate for rear
glass assembly.
3. Place rear glass assembly into notches in appliance and
tilt upright into position. While holding glass in position,
reattach glass retainer with fasteners saved in Step1.
Do not overtighten.
4. Slide left glass assembly into left side of appliance.
Attach glass retainer with fasteners saved in Step 1. Do
not overtighten. See Figure 14.11.
5. Slide right glass assembly into right side of appliance.
Attach glass retainer with fasteners saved in Step1. Do
not overtighten.
A
LEFT
LUX36 26-5/8 IN.
LUX42 31-5/8 IN.
Figure 14.9 Refractory Glass Panels
RETAINER BRACKETS
NOTCHES FOR REAR GLASS PANEL
Figure 14.10 Remove Retainer Brackets
54
REAR RIGHT
B
A B
23-5/8 IN.
29-5/8 IN.
Heat & Glo • LUX36, LUX42 • 2287-900 Rev. J
Figure 14.11 Side Panel Installation
Figure 14.12 Glass Refractory Installed
• 2287-900 Rev. J • 6/13