Heat & Glo PRIMO60 Installation Manual page 62

7. Set transition media tray into position as shown in Figure
10.16. The return bends are at the bottom of the tray.
The rear return bend should be positioned in between
the glass frame and the glass frame bracket. Ensure
tray is positioned fl ush with appliance opening.
Figure 10.14 Form Transition Glass Panel Bracket
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
62
FORM FORM
HAND BEND HAND BEND
8. Install glass transition panel bracket on left and right
sides of appliance opening using two self-tapping
screws. See Figures 10.14, 10.15 and 10.16 for details.
9. Install transition glass panels by securing with tabs on
left and right sides of appliance. See Figures 10.16
and 10.17.
INSIDE VIEW OF OUTER WRAP
TRANSITION GLASS PANEL BRACKET
SELF-TAPPING SCREWS GO SELF-TAPPING SCREWS GO
THROUGH EXISTING HOLES THROUGH EXISTING HOLES
EXISTING HOLES EXISTING HOLES
Figure 10.15 Install Transition Glass Panel Bracket