•
Install the HEAT-ZONE-PRIMO collars on the left and
right sides of the appliance with screws. See Figure
6.7.
•
Attach included air duct to the HEAT-ZONE-PRIMO
collars with gear clamps. See Figure 6.8.
•
Attach both mounting brackets to the fan housing.
See Figure 6.8.
•
Mount fan housing in desired location. See Figures
6.5, 6.10 and 6.11.
•
Attach round to oval adapter to fan housing with two
screws. See Figure 6.8.
•
Attach included fl exible ducts to round to oval adapter
with gear clamps.
Note: 6 Inch metal duct can be used in place of the in-
cluded fl exible ducts.
WARNING! Risk of Fire! HEAT-OUT-PRIMO seal plates
MUST remain installed. Appliance could overheat.
HEAT ZONE
®
COLLAR LOCATION
LEFT AND RIGHT SIDES
DO NOT
REMOVE
KNOCKOUTS
Figure 6.7 HEAT-ZONE-PRIMO
WARNING! Risk of Fire! DO NOT fold/kink/pinch/ob-
struct 6 inch fl exible ducts. Appliance could overheat.
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. L • 2/16
30
SQUARE
VENT
PIPE GASKET
Figure 6.8
HEAT-OUT-PRIMO
SEAL PLATES
MINIMUM SPACE
90 DEGREE BEND
Figure 6.9
Mounting Bracket
(Both Sides)
Screws
Gear Clamp
18 in.
REQUIRED FOR
Fan Housing
Round to Oval Adapter
Gear Clamp
6 in. Round Air Duct
6-3/4 in.