Trial Run - FP ultimail Operator's Manual

18 ultimail Operator Manual
4.3

Trial run

Letter guide face
In the same way you can position an empty envelope for trial run at the sealer
or at the feeder. For details on how to use sealer and feeder, read Chapter 6.
Using the
SET UP
SYSTEM SETTINGS
PRINT
ZERO-RATED POSTAL INDICIA
key you can print the zero imprint on an FP label.
You can check the settings for metering
(e.g. logo) and the print quality by printing
a test imprint with postage value "0.00"
(zero-rated postal indicia).
The ultimail prints a normal meter imprint
with the postage value "0.00".
• Go to the SET UP menu using the
key.
• Select SYSTEM SETTINGS
ZERO RATED POSTAL INDICIA.
• Place an empty envelope on the letter
receiving tray:
– side to be printed face up
– the upper edge flush to the letter
guide face.
• Push the envelope in until the letter
sensor recognizes the envelope and
starts letter transport.
The ultimail feeds the envelope, prints,
and places the printed envelope in the
catch tray.
End "Zero imprint" mode
• Keep the key pressed for approx.
3 seconds.
The ultimail goes back to METERING
mode.
PRINT