Sponge
Cut-out
Checks:
Sponge closely below the bars
(without protrusion)
Basket on the
extreme left
Basket flushed on top
Basket
• Lift the basket with the sponge out of
the water tray. Remove sponge from
basket.
• Clean sponge or replace with a new
one.
• Put a new sponge into water before
inserting it, and let soak completely.
The flaps are thus correctly moistened
from the first letter on.
• Insert sponge in basket.
Sponge must be closely positioned to
the bars and rest on the lateral limit.
Ensure that sponge is not pressed by
the bars. Two flaps on the longitudinal
side hold sponge to the basket.
• Insert basket into water tray as shown
in the figure. Mind the position of the
cut-out.
• Check if the basket is correctly seated:
It must rest on the extreme left in the
water tray and close on top in a flushed
manner.
• Insert the complete water tray into the
housing until it clicks into place.
• Check if the sponge is correctly seated.
It should be directly below the
moistening felt and brush.
Maintenance and care
123
Need help?
Do you have a question about the ultimail and is the answer not in the manual?