System Management; Updating Firmware - AMX NMX-ENC-1100 Instruction Manual

Web Configuration

System Management

FIG. 30 displays the system management controls on the NMX-ENC WebConsole page. The system management
controls allow you to update the firmware, reboot, or restore the default settings for the encoder.
FIG. 30
System Management tab
The following options are available in this area:
System Management Options
Firmware
Enable Streaming Indicator
Relay
Dim LEDs
Disable Switch
Restore Default Settings
Reboot

Updating Firmware

You can view your current firmware in the Firmware Version field on the System Management tab. Follow these steps to
upgrade the firmware on the NMX-ENC:
Download the latest firmware kit file for the NMX-ENC from www.amx.com. Save or copy the kit file to a hard
1.
drive, USB drive, or flash drive accessible by the encoder.
Open WebConsole in a web browser. See the Accessing the WebConsole section on page 23 for more information.
2.
Select the System Management tab.
3.
Click Select File.
4.
Navigate to the directory where the kit file is saved or stored, and select the kit file.
5.
Click Update Firmware. The 4 LEDs on the front panel of the encoder (Stream, Video In, Power, and USB) begin
6.
flashing indicating the firmware is processing. If a streaming session is in progress when the firmware update
begins, it will be terminated. When the firmware update is complete, all LEDs stop flashing.
30
The Firmware area displays the current firmware version. Click Update
Firmware to update the device's firmware to the latest version. Click Reset to
Factory Firmware to restore the device's firmware to its factory default version.
Click the check box to enable the streaming relay on the encoder. The
streaming relay is the INDICATORS port labeled (1) on the rear panel.
Click the check box to dim the LEDs on the front panel of the encoder.
Click the check box to disable LAN ports 2-4.
WARNING! Since it is possible to turn off these ports, you should ALWAYS
connect your main network artery to port 1.
Click to restore the factory default settings for the device. This option only
restores the default settings. It does not revert to a previous firmware version.
Click to reboot the device.
Instruction Manual - NMX-ENC H.264 Encoder