Networking - AMX NMX-ENC-1100 Instruction Manual

Networking

FIG. 29 displays the network controls on the NMX-ENC WebConsole page. The network controls allow you to set up
your DHCP or Static network.
FIG. 29
Networking tab
The following options are available in this area:
Networking Options
DHCP/Static
IP Address
Subnet Mask
Gateway
DNS
Instruction Manual - NMX-ENC H.264 Encoder
Click the corresponding option button to select a DHCP or Static
communication mode.
• DHCP (Dynamic Host Configuration Protocol) assigns IP addresses from
client stations logging onto a TCP/IP network via a DHCP server.
• Static IP is a permanent IP address that is assigned to a node in a TCP/IP
network.
Enter the IP address or URL used by the encoder. The target address must be
in IPv4 dot notation (ex: X.X.X.X). This option is only available if you select a
static network.
Enter the subnet mask address in the provided field. This option is only
available if you select a static network.
Enter a value for the gateway in the provided field. This option is only available
if you select a static network.
Enter the up to three DNS addresses in the provided fields. You must enter
each DNS address separately in the three available fields. These fields are
optional. These options are only available if you select a static network.
Web Configuration
29