Keypad; Indicators - AMX NMX-ENC-1100 Instruction Manual

KEYPAD

The rear panel features one 3-pin 3.5mm Phoenix connector for RS-232 ports for controlling the encoder by keypad or
ControlPad. This connector is reserved for future use. The pin-outs for this port are as follows:



FIG. 15 displays the KEYPAD port.
FIG. 15 KEYPAD port
The KEYPAD port supports the following data rate and format:






INDICATORS

The rear panel features one 4-pin 3.5mm relay port for connecting up to two independent relay devices. The port features
a 2-pin Streaming port (Port 1). Port 2 is reserved for future use. Each respective relay port is "ON" when the encoder
is streaming or recording. When a relay is "OFF", terminals A and B are open-circuit. FIG. 16 displays the
INDICATORS port.
FIG. 16 INDICATORS ports



Instruction Manual - NMX-ENC H.264 Encoder
Pin 1: GND (G)
Pin 2: RXD (R)
Pin 3: TXD (T)
Baud rate: 115200
Parity: None
Data Bits: 8
Stop Bits: 1
Software handshaking with XON & XOFF: Off
Each relay is isolated and normally open.
Each relay is independently controlled
Each relay can switch up to 24 VDC or 28 VAC peak @ 1 A
Wiring and Device Connections
11