Netlinx - AMX NMX-ENC-1100 Instruction Manual

NetLinx

FIG. 31 displays the NetLinx controls on the NMX-ENC WebConsole page. The NetLinx controls allow you to set up a
connection to a central controller.
FIG. 31
NetLinx tab
The following options are available in this area:
NetLinx Options
Master Mode
IP/URL
Port
Device No
System No
Instruction Manual - NMX-ENC H.264 Encoder
Select the NetLinx Master mode from the menu. You can choose from URL or
Auto.
• URL instructs the encoder to connect to a specific NetLinx Master at the
defined URL. This setting is used when the IP Address of the target NetLinx
Master is known. In this system, the encoder acts as a client and the Master
acts as a server (in that clients attach to it). In URL mode, you can only enter
the IP/URL of the target Master. The System Number is 0 (for an unknown
System Number) and the port number defaults to 1319.
• Auto is used to instruct the encoder to search for a Master that both uses
the same System Number (assigned within this page's System No field) and
resides on the same Subnet as itself. In this case, the Master has its UDP
feature enabled.
Enter the IP Address or URL used by the target Master in the provided field.
Note: This is the same IP Address used by NetLinx Studio to communicate
with the Master.
Enter the port number used by the NetLinx Master in the provided field. The
default value is 1319.
Enter a current device value (non-duplicated) in the provided field. You must
use a value which is not currently being used by another device currently
communicating with the target Master.
In NetLinx Studio, use the Online Tree tab to review what device values are
already being used by the target Master.
Enter a system number in the provided field. This option is not available if you
set the NetLinx Master mode to Auto.
Web Configuration
31