Web Configuration; Nmx-Enc Webconsole; Accessing The Webconsole; Retrieving The Ip Address Of The Encoder - AMX NMX-ENC-1100 Instruction Manual

Web Configuration

NMX-ENC WebConsole

The NMX-ENC WebConsole interface is provided for configuration. Using a standard web browser, enter the IP address
of the NMX-ENC for WebControl. The primary page is presented as the NMX-ENC Configuration Manager (unless
security is enabled, in which case you will see user login page). The NMX-ENC supports Internet Explorer 9 or better,
Firefox (21.0+), and Chrome (27+).

Accessing the WebConsole

You can access the WebConsole by opening a supported web browser from a PC and entering the IP address of the
encoder in the location bar in the browser.

Retrieving the IP Address of the Encoder

You can retrieve the IP address and other configuration information for the encoder by inserting a USB drive into the
encoder and pressing the ID pushbutton. The encoder creates and copies a text (.txt) file to the USB drive with a list of
configuration information including the IP address of the encoder. Perform these steps to locate the IP address of the
encoder:
Insert a USB drive into the USB port on the front panel of the encoder. The USB LED beside the port appears green
1.
once the USB drive is mounted.
Press and hold the ID pushbutton for two seconds until the USB LED appears red. When the LED appears red, the
2.
encoder is copying a .txt file to the USB drive. The encoder is finished transferring the file to the USB drive when
the LED appears green again.
Remove the USB drive from the encoder and insert it into a PC or any other device which can read the file.
3.
On the PC, navigate to the USB drive. The filename contains the encoder's serial number, IP address, and IP type
4.
(DHCP or Static). You can open the file to view the MAC address, subnet mask, gateway, and DNS. FIG. 24
displays an example of a configuration file.
Note: If the encoder is unable to receive the IP address at the time of retrieval, the filename will have "unavailable"
listed in place of the IP address.
FIG. 24
Encoder configuration file
Note: Writing the configuration file to the USB drive can only occur once per drive insertion. If you need the encoder to
copy the file another time, you must remove the USB drive and insert it again into the USB port on the front panel.
Instruction Manual - NMX-ENC H.264 Encoder
The filename contains the encoder's
serial number, IP address, and IP type.
IP Type
IP Address
Web Configuration
Serial Number
23