AMX NMX-ENC-1100 Instruction Manual page 15

ID
The front panel features an ID pushbutton which allows you to retrieve the IP address and other configuration
information for the encoder. You can retrieve this information by inserting a USB drive into the encoder and pressing the
ID pushbutton. The encoder creates and copies a text (.txt) file to the USB drive with a list of configuration information
including the IP address of the encoder.
Note: When a USB drive is attached to the encoder, the ID pushbutton is limited to only retrieving IP address
information. You cannot use the ID pushbutton with Identity Mode in NetLinx Studio unless there is no USB drive
present.
FIG. 7 displays the ID pushbutton.
FIG. 7 ID pushbutton
The ID pushbutton performs as follows:


Note: Writing the configuration file to the USB drive can only occur once per drive insertion. If you need the encoder to
copy the file another time, you must remove the USB drive and insert it again into the USB port on the front panel.
Instruction Manual - NMX-ENC H.264 Encoder
To use in conjunction with the ID Mode feature in NetLinx Studio, press the button once to assign a device
address to the device.
To retrieve the configuration information about the device, press and hold the button to write the
configuration file to a USB drive connected to one of the front panel USB ports.
Wiring and Device Connections
7