Table of Contents
Advertisement
Figure 1-3. Installing the I/O Shield on the Motherboard
Motherboard
To install a PATX3070 motherboard in your chassis, refer to
page 1-17
Motorola unit. With other chassis, the procedure may differ slightly.)
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Ensure that the AC or DC power is switched off and remove the AC
Inserting or removing modules with power applied may result in damage
to module components.
Caution
http://www.motorola.com/computer/literature
and follow the procedure below. (The chassis shown is a
strap to an electrical ground (refer to
page
1-13). The ESD strap must be secured to your wrist and to
ground throughout the procedure.
cord or DC power lines from the system.
Hardware Installation
2812 0800
Figure 1-4 on
Installation Preliminaries on
1
1-15
Advertisement
Table of Contents
