Hardware Installation; Installing The Mvme6100 Into A Chassis; Table 1-4. Configuration Switch (S4) - Motorola MVME6100 Installation And Use Manual

Hardware Preparation and Installation
1

Hardware Installation

Installing the MVME6100 into a Chassis

1-12
When the Safe Start switch is set OFF, normal boot sequence should be
followed by MOTLoad. When ON, MOTLoad executes Safe Start, during
which the user can select the Alternate Boot Image.

Table 1-4. Configuration Switch (S4)

POSITION 4
FUNCTION
FACTORY OFF
DEFAULT WP
The S4 Configuration Switch is set with the following default settings:
Use the following steps to install the MVME6100 into your computer
chassis.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to an electrical ground (refer to
3
ON
No WP
1 Switch 1 - OFF
2 Switch 2 - ON
3 Switch 3 - ON
4 Switch 4 - OFF
4295 0604
Unpacking
Computer Group Literature Center Web Site
2 1
ON OFF
Bank B Norm ENV
Guidelines). The ESD