Yamaha XT1200Z 2010 Service Manual page 496

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Actuation
Procedure
Probable cause of mal-
Item
function and check
1 Connection of cylinder-#1
left ignition coil coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
2 Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3 Wire harness continuity.
4 Installed condition of cylin-
der-#1 left ignition coil.
Check for looseness or
pinching.
5 Defective cylinder-#1 left ig-
nition coil.
email: info@motomatrix.co.uk
33
Cylinder-#1 left ignition coil: open or short circuit detected in
the primary lead of the cylinder-#1 left ignition coil.
Able to start engine (depending on the number of faulty cylinders)
Able to drive vehicle (depending on the number of faulty cylinders)
d:30
Actuates the cylinder-#1 left ignition coil five times at one-second
intervals.
Illuminates the engine trouble warning light.
Check that a spark is generated five times.
• Connect an ignition checker.
Maintenance job
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness.
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness.
Open or short circuit → Re-
place the wire harness.
Between cylinder-#1 left igni-
tion coil coupler and ECU
coupler.
orange–orange
Improperly installed sensor
→ Reinstall or replace the
sensor.
Execute the diagnostic
mode. (Code No. d:30)
Measure the primary coil re-
sistance of the cylinder-#1
left ignition coil.
Replace if defective.
Refer to "CHECKING THE
IGNITION COILS" on page
8-147.
8-47
FUEL INJECTION SYSTEM
Confirmation of service
completion
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 2.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 3.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 4.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 5.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 6.